- MIC INPUTS - Three electronically
balanced type with XLR connector, High Pass Filter, 6 position Input Gain
Selector, rotary level control, 48V Phantom/12V T (AB) Powering.
- MIC/LINE - Each input is switchable to
line level giving the same degree of control as for mic input.
- ROUTEING - Each input routed to left
or right output using a centre detent panoramic potentiometer.
- OUTPUT - Transformer balanced with
XLR Type connector, rotary stereo level control.
- 10 PIN MULTIWAY CONNECTOR - Contains
left and right main output signals and left and right return signals to the
monitor path. This allows a single connection to the recording media, e.g.
Cameras. It can be used simultaneously with the XLR outputs.
- LIMITER - Incorporated in the main
outputs. A push switch introduces the limiter into circuit and a further
switch enabling left and right signal paths to be linked. Two LEDs indicate
the onset of limiting.
- LINE UP OSCILLATOR - 1k Tone into
- TALKBACK/SLATE - An internal
electret microphone allows a 'slate' signal to be added to the main outputs
and a TALK switch enables communication to a third party on a separate
- MONITORING - Headphones on Type A
Jack with rotary switch to select pre-fade input, main output: left or right
only or stereo. Three push buttons operate in conjunction with the rotary
switch. MONO enables the monitor signal to be converted from stereo to
monarual; RET allows the return signal to be monitored in the format
selected by the rotary switch; MTX decodes an M-S signal to the L-R domain
and visa-versa. A second monitor output allows a third party to receive a
monitor feed, which also includes a private line (TALK) facility. This
second monitor can be configured, using internal DIL switches, to receive
inputs 1 or 2 or both, giving the opportunity to send the boom operator
his/her own signal if they are the receiver.
- METERING - LCD type giving
indication of left and right output levels, battery status and direct/return
monitor selection. A back-light facility assists use in low ambient light
- POWERING - Internal batteries using
6 x AA cells or an external supply with a source voltage 9V to 15V DC. A LED
indicates the mixer is ON and also flashes when battery level is low. A
small 4 pin connector enables other external equipment, such as radio
microphone receivers to be powered.